why-does-my-tv-say-no-signal

I have an HD Flat Display TV and also when I turn it on says NO SIGNAL. Do i need to call a TV techniciantexnikoi tv – ?I have not seen this before as my CABLE TELEVISION BOX is connected and turned ON. I do not understand if there may be something incorrect with my TV or if it is the cable television box causing my trouble. I know my TELEVISION works since I can see it displaying words “NO SIGNAL“. Is there possibly glitch with the TELEVISION where the cords go in on the back of the TELEVISION?

If your TELEVISION presents a “No Signal” message on the display (HDTV or Typical TV) maybe one of the 4 problems we have listed below …

1. Is the NO SIGNAL issue taking place on simply one TELEVISION?

CORRECT INPUT or RESOURCE

If it is simply one Sony TELEVISION that is revealing the NO SIGNAL …
– Make certain your TV is on the correct resource or input as your CABLE TELEVISION or SATELLITE BOX.
– Press the TV button on TV push-button control to turn your TELEVISION ON.
– Press the INPUT button on your TELEVISION remote.
– Cycle with all the inputs on your TV.
– Do this up until you are on the INPUT your WIRE or SATELLITE BOX is plugged into.
– You ought to then see the CORD or SATELLITE programs show on your TV.

HINT: Your TV will more than likely listing the TELEVISION INPUTS as: HDMI 1, HDMI 2, HDMI 3, VGA, Part 1, Part 2, and so forth.

If you still see NO SIGNAL on your TELEVISION screen, see the following action listed below …

2.  Did you have your TV on the proper INPUT or SOURCE and also you still see NO SIGNAL ?

WIRE OR SAT BOX NEEDS RESET

– Remove or disconnect the power line from the Cable television or SATELLITE set top box.
– Keep it unplugged for 2 to 3 minutes.
– Plug the power cable back right into your Cable or SATELLITE set leading box.
– Give it time for the Cable television or SATELLITE box to power up, obtain the signal, and boot up.

If you still see NO SIGNAL on your TELEVISION display, see the following step listed below …

 

3. Did you reset the Cord or SAT box and still have the NO SIGNAL?

UNPLUG THE CORD GOING FROM THE TV TO YOUR WIRE OR SAT BOX

– Eliminate the HDMI cord or various other cables from your Cable television or SATELLITE set leading box.
– Maintain the cable unplugged for 2 to 3 minutes.
– Plug the HDMI cable television or other cords back in.
– Give it some time for the Wire or SATELLITE box to get the signal as well as boot up.

TIP: Make certain all the cable televisions that are attached to your Cable or SATELLITE box and your TV are tight, undamaged, and protected.

4. Is still your Televisions impacted with the NO SIGNAL display?

BE SURE THE COAX CABLES OR ETHERNET CABLES ARE SECURE or WIRE OR SAT IS DOWN MOMENTARILY

-Make sure to examine the ones where the CABLE TELEVISION or SATELLITE enter into your house.
-Make sure ALL Ethernet and also Coax cables are safe.
-Call your CORD or SATELLITE company to see if there is a failure.
-Straighten your Dish if you have SATELLITE.

Not Fixed yet?

If you’ve still not had any kind of success and also you still have no signal on the TV, after that simply connect with 24gr.gr! They offer a very popular TV service warranty cover developed at protecting you if emergency situations happen! Simply get in touch with them or visit their internet site to send an email. Our technical team can run you through some easy troubleshooting tips to try as well as repair it over the phone. However if not we have a devoted team of producer engineers just waiting ahead and assist you fix your TV.

See more about TV Technicians :